DC Contactor 100Amp Type S9000

These solenoids are heavy duty, single winding dc solenoids designed for continuous operation at low current input, so that they can be operated on the engine without the need of a separate relay for high current.

These solenoids are normally used in ‘energize to run’ mode, giving a fail-safe system. Since they draw a current of only around 2 Amps while pulling and holding, therefore there is no danger of burnout and the solenoids can remain in ON condition for days.

Specifications

• Coil voltages 24 V DC 110 VDC

• Coil Resistance 30 ohms 300 ohms

• Coil current 0.8 A 0.3 A

• Contact Rating 100 A resistive at 110 V DC

• Contact Combination 1 N/O + 1 N/C double break+ Aux. Contact 1 N/O + 1 N/C

• Operating Time 20-50 msec

• Insulation Resistance 100 Mohms at 500 V DC

• Life expectancy 1,00,000 electrical cycles

• Dielectric strength between live and ground : 2000 V for 1 min between contacts of same polarity 1000 V for 1 min

• Mounting Chassis mounting 4 holes of 4 mm dia.

• Dimensions (approx.)L 103 mm B 83 mm H 125 mm

• Weight 1.850 gms.